Chapter 8: Using the Command Line Interface
347
EAP CA Certificate Example
This section provides a CA certificate example only. Your CA certificate
contents should be different from the contents displayed in this example.
To provide a CA certificate:
1. Make sure you have entered the configuration mode. See
Entering
Configuration Mode
(on page 338).
2. Type the following command and press Enter.
config:#
network wireless eapCACertificate
3. The system prompts you to enter the contents of the CA certificate.
4. Open a CA certificate using a text editor. You should see certificate
contents similar to the following.
5. Select and copy the contents as illustrated below, excluding the
starting line containing "BEGIN CERTIFICATE" and the ending line
containing "END CERTIFICATE."
Summary of Contents for EMX2-888
