Raritan EMX2-888, User Manual

Page: 150 / 568

Chapter 6: Using the Web Interface
136
To configure the analog modem settings:
1. Click the Analog Modem tab.
2. Select the "Answer incoming calls" checkbox to enable the remote
access via a modem. Otherwise, deselect this checkbox.
3. Specify the number of rings the EMX must wait before answering the
call. You can either type a value or click the Up/Down arrow keys to
adjust the value in the "Number of rings until answering" field.
To configure the GSM modem settings:
1. Click the GSM Modem tab.
2. Enter the SIM PIN.
3. Select 'Use custom SMS center number' if a custom SMS will be
used.
4. Enter the SMS center number in the SMS Center field.
5. Click Advanced Information to show information.
6. Enter the number of the recipient's phone in the Recipients Phone
field, then click Send SMS Test to send a test SMS message.
Setting the Cascading Mode
A maximum of eight EMX devices can be cascaded using USB cables
and therefore share only one Ethernet connection. See
Cascading the
EMX via USB
(on page 22).
The Ethernet sharing mode applied to the USB-cascading configuration
is either network bridging or port forwarding. This mode is determined by
the master device. See
Overview of the Cascading Modes
(on page
138).
Only the Admin user or a user with the Administrator Privileges
permission can configure the cascading mode.
To apply the "Port Forwarding" cascading mode, all cascaded EMX
devices must be upgraded to version 2.5.20 or later, or those devices not
supporting the "Port Forwarding" mode cannot be accessed over the
network. See
Updating the EMX Firmware
(on page 291).
Note: The EMX in the Port Forwarding mode does not support APIPA.
See
APIPA and Link-Local Addressing (on page 4).
To configure the cascading mode:
1. Log in to the master device's web interface.
2. Choose Device Settings > USB Cascading. The USB Cascading
Configuration dialog appears.