Printronix P9012, Maintenance Manual

Page: 100 / 256

5–16 Alignments and Adjustments
Hammer Tip Alignment
(Figure 5–6)
1. Remove the ribbon deck assembly as described on page 6–8 of Chapter
6, Replacement Procedures.
2. Perform steps 1 and 2 of the hammer spring removal procedure, as
described on page 6–22 of Chapter 6, Replacement Procedures. This will
place the hammer bank in the service position.
3. Loosen the screw (1) of the hammer spring (2) to be aligned.
4. Place the alignment tool (3; P/N 132266–001) over the hammer tips.
Move the hammer spring until the tip is in an appropriate hole in the
alignment tool.
5. Torque the screw to 6 to 8 in–lbs and remove the tool.
6. Return the hammer bank to the operating position as described on page
6–24 of Chapter 6, Replacement Procedures.
7. Install the ribbon deck assembly as described on page 6–8 of Chapter 6,
Replacement Procedures.