Connecting by No-protocol Communications
ZW User's Manual
353
Senso
r con
trol
ler ope
ra
ti
ons
9
Setting Communications Specifications (RS-232C Communications)
Setting Communications Specifications (RS-232C Communications) p.230
Operating procedure
Steps
Key operation
Display
Description
1 to 3
For moving to "COM", see steps 1 to 3 in p.350.
4
Press the
/
keys to select "RS232C" and press the
key.
5
Select the setting item:
BAUD.RT: baud rate
DATA: data length
PARITY: parity
STOP: stop bit
CS/RS: CS/RS control
In this example, press the
/
keys, select "DATA" and press the
key.
6
Selects the data length.
The current setting value is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
Select the data length, and press the
key.
7
Press the
key to return to the previous menu.
8
Press the
/
keys to select "PARITY" and press the
key.
9
Repeat steps 6 to 8 to set other items.
10
Press and hold the
key for two seconds to enter the RUN mode.
Summary of Contents for ZW-C1*AT
