Connecting with EtherCAT
348
ZW User's Manual
9-13Connecting with EtherCAT
Setting Fieldbus
Setting default settings for EtherCAT communications p.165
Operating procedure
Steps
Key operation
Display
Description
1
Press and hold the
key for two seconds to enter the FUN mode.
2
Press the
/
keys to select "SYSTEM" and press the
key.
3
Press the
/
keys to select "COM" and press the
key.
4
Press the
/
keys to select "MEMLNK" and press the
key.
5
Select the Fieldbus.
E-CAT: EtherCAT communications
EIP: EtherNet/IP communications
OFF: OFF
The current setting value is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
Select "E-CAT" and press the
key.
6
Press the
key for two seconds to enter the RUN mode.
Summary of Contents for ZW-C1*AT
