Displaying measured values in graphs
ZW User's Manual
123
5
Conve
n
ien
t Fu
nctions
4
Set the trigger condition.
• When the trigger target is "Data slope"
• When the trigger target is "Data window (In)"
• When the trigger target is "Data window (out)"
• When the trigger target is "Input and output"
Item
Setting item
Range
Description
Trigger condition Condition
=
When the measurement results are the same value as the
judgment value, the trigger condition is considered to have
been met.
When the measurement results are a different value from
the judgment value, the trigger condition is considered to
have been met.
>
When the measurement results are greater than the
judgment value, the trigger condition is considered to have
been met.
When the measurement results are greater than or equal to
the judgment value, the trigger condition is considered to
have been met.
<
When the measurement results are less than the judgment
value, the trigger condition is considered to have been met.
When the measurement results are less than or equal to
the judgment value, the trigger condition is considered to
have been met.
Judgment
-999.999999 to
999.999999 mm
This is the judgment value for the measurement results.
Item
Setting item
Range
Description
Trigger condition Judgment value
1
-999.999999 to
999.999999 [mm]
When the measurement results are greater than or equal to
judgment value 1 and less than or equal to judgment value
2, the trigger condition is considered to have been met.
Judgment value
2
-999.999999 to
999.999999 [mm]
Item
Setting item
Range
Description
Trigger condition Judgment value
1
-999.999999 to
999.999999 [mm]
When the measurement results are less than judgment
value 1 or greater than judgment value 2, the trigger
condition is considered to have been met.
Judgment value
2
-999.999999 to
999.999999 [mm]
Item
Setting item
Range
Description
Trigger condition Condition
TRUE (rising)
When the I/O signal rises, the trigger condition is
considered to have been met.
False (falling)
When the I/O signal falls, the trigger condition is considered
to have been met.
Summary of Contents for ZW-C1*AT
