Omron ZW-C1*AT, User Manual

Page: 336 / 450

Setting the System
334
ZW User's Manual
9-11Setting the System
Display/set the system environment.
Checking Information
Display the set measuring cycle and information of the Sensor Controller and Sensor Head.
Checking Information p.114
As an example, here is an explanation of the procedure for displaying the serial No. of the Sensor Head.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUN
mode.
2 Press the / keys to select "SYSTEM" and press the
key.
3 Select the information to display.
CYCLE: Currently set measurement cycle [ms]
C.INFO: CONTROLLER INFORMATION
H.INFO: SENSOR HEAD INFORMATION
In this example, press the / keys, select "H.INFO" and
press the key.
4 When the Controller information and Sensor Head information have
been changed, select the additional information to display:
VER: Controller version information
MAC.ADR: Controller MAC address
MODEL: Sensor Head model information
SER.NO: Sensor Head serial No.
In this example, press the / keys, select "SER.NO" and
press the key.
5 - "SER.1" is displayed on the main display and the higher-order digit
of the serial No. is displayed on the sub-display.
6 When the / key is pressed, "SER.2" is displayed on the
main display and the lower-order digit of the serial No. is displayed
on the sub-display.
7 Press the key for two seconds to enter the RUN mode.