Setting the Output Conditions
100
ZW User's Manual
Hold clearing conditions
Held values can be cleared by the following operation.
• When FUN (adjustment) mode/RUN (operation) mode is switched
• When hold RESET is entered (32-pole extension connector,
key)
• Hold RESET command is entered.
(Example) Peak
(Example) Auto Peak
If an abnormal measured value is obtained during sampling, the hold value is cleared. To not clear the hold value even
if an abnormal measured value is obtained, set "KEEP" as the non-measurement setting.
Setting operation when measurement is not possible p.148
When the hold value is reset,
the clamp level is output until
the next hold value is applied.
The mode is switched between
the FUN mode and RUN mode
FUN mode
RUN mode
Sampling
Sampling
Hold value
Measurement
value
Clamp level
When RESET is executed
(32-pole extension connector/key input/command).
The mode is switched between
the FUN mode and RUN mode
FUN mode
RUN mode
Hold value
Measurement
value
Clamp level
When RESET is executed
(32-pole extension connector/key input/command).
Important
Summary of Contents for ZW-C1*AT
