Setting the Output Conditions
ZW User's Manual
323
Senso
r con
trol
ler ope
ra
ti
ons
9
Setting the Offset
As an example, here is an explanation of the procedure for selecting the "10 mm" reference value setting.
Operating procedure
Steps
Key operation
Display
Description
1 to 5
For moving to "ZERO", see steps 1 to 5 in p.322.
6
Press the
/
keys to select "OFFSET" and press the
key.
7
Change the offset value.
The current setting value is displayed on the sub-display.
Press
key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the
/
/
/
keys.
In this example, input "10", then press the
key.
8
The decimal point is displayed.
Press the
/
key to move the decimal point.
Determine the decimal point and then press the
key.
9
Press the
key for two seconds to enter the RUN mode.
Summary of Contents for ZW-C1*AT
