Parallel I/O connection
140
ZW User's Manual
Settings for Analog Output
The following describes the settings for outputting the current measurement results from the analog output of
the analog output terminal block.
Setting the analog output destination
With analog output, the measurement results can be output converted to a current from 4 to 20 mA or a voltage
from -10 to +10 V.
Selects which to output, the current or the voltage.
The same output destination is set for all banks. The output destination cannot be set separately for individual banks.
Explorer pane
: [Device Group] | [(Sensor Name)] | [System]
[System Data] (double-click)
Edit pane
: [Sensor settings] icon (
)
Item
Setting item
Setting value
Description
Sensor settings
Analog output
Voltage output
(default value)
Voltage output
Current output
Current output
1
Set the operating mode to the FUN mode.
3-3 Switching operation modes p.61
2
Select the output destination from [Analog
output].
The analog output destination can also be set with key operations on the Sensor Controller.
Setting the analog output destination p.338
Important
Note
Summary of Contents for ZW-C1*AT
