Parallel I/O connection
ZW User's Manual
155
6
Commun
ication
s with Exte
rnal De
vi
ces
Hold (sampling)
Explanation of operations
(1) The TIMING input is turned ON.
(2) During the TIMING input minimum time, when the TIMING input is ON, sampling is started and the BUSY
output is turned ON. The measurement result is sampled and the judgment result is output.
(3) After the judgment result output, the analog output is updated.
(4) The RESET input is turned ON. If the RESET input is turned ON during the RESET input minimum time, the
measured value is reset.
(5) The judgment result and is reset.
(6) After the judgment result output, the analog output is reset.
(7) The RESET input is turned OFF.
When the setting for non-measurement is "CLAMP", if the sampling value is an abnormal value or an undetermined
value
*
, sampling is not executed. The output value is as follows.
• Hold the clamp value.
• The BUSY signal is not turned ON.
*: After the start of measurement, if measurement results are not obtained the number of times required to take the
average, the measurement result is not applied.
Item
Min.
Max.
T3
Response time of analog output
0.1 ms
T4
TIMING input/RESET input minimum time
3ms+T0
T5
Input response time
2ms+T0
3ms+T0 × 2
(1)
(2)
(3)
(4)
(5)
(6)
(7)
T3
J
u
dgment o
u
tp
u
t
(HIGH/PASS/LO
W
)
Analog o
u
tp
u
t
TIMI
N
G inp
u
t
RESET inp
u
t
BUSY o
u
tp
u
t
T5
T4
O
N
OFF
O
N
OFF
O
N
OFF
T3
T5
T4
Important
Summary of Contents for ZW-C1*AT
