Switching operation modes
ZW User's Manual
297
Senso
r con
trol
ler ope
ra
ti
ons
9
Entering Numerical Values
To enter numerical values, including parameters, for the sub-display, follow the steps below:
(1) When entering numerical values, the sub-display displays the current setting value and its uppermost digit
flashes.
(2) Press the
/
keys to select a digit to enter a number.
Press the
key on the rightmost digit to move blinking to the leftmost digit.
Press the
key on the leftmost digit to move blinking to the rightmost digit.
(3) Press the
/
keys to select a digit to enter a number.
(4) Press the
key to apply the entered value.
Positioning decimal point
To position a decimal point, follow the steps below:
(1) If a decimal point has been defined, it flashes on the sub-display.
(2) Press the
/
keys to position the decimal point.
Position the decimal point at the rightmost digit to erase it.
Press the
key on the rightmost digit to move blinking to the leftmost digit.
Press the
key on the leftmost digit to move blinking to the rightmost digit.
(3) Press the
key to apply the position of the decimal point.
Apply
Select
digit
S
ub
-display
(Parameter)
Select
v
al
u
e
Apply
Select
position
S
ub
-display
(Parameter)
Summary of Contents for ZW-C1*AT
