Setting Threshold Value
ZW User's Manual
333
Senso
r con
trol
ler ope
ra
ti
ons
9
Direct
Set the threshold value by entering the numerical values directly.
As an example, here is an explanation of the procedure for setting a HIGH threshold value by entering "40.000"
directly.
Operating procedure
Steps
Key operation
Display
Description
1 to 4
For moving to JUDGE, see steps 1 to 4 on p.332.
5
Press the
/
key to select DIRECT, then press the
key.
6
Select HIGH THRESHHOLD as the threshold value type.
Press the
/
key to select H.JUDGE, then press the
key.
7
Set "40.000" as the HIGH threshold value.
The current measured value is displayed on the main display and the
current set threshold value is displayed on the sub-display. (At this
time, the THRESHOLD-H indicator lights up.)
Press
key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the
/
/
/
keys.
Enter "40.000" and press the
key.
8
Press and hold the
key for two seconds to enter the RUN
mode.
Summary of Contents for ZW-C1*AT
