Displaying measured values in graphs
ZW User's Manual
121
5
Conve
n
ien
t Fu
nctions
3
Select data to monitor the trend for.
Set data to monitor the trend for.
The types of data that can be set are as follows.
4
Set the logging sampling interval.
Set the logging sampling interval for the target data.
5
Click the Start icon (
) to start the sampling.
When the sampling starts, the sampled data is displayed in the graph.
6
Click the End icon (
) to end the sampling.
When the sampling ends, the graph display stops too.
Item
Setting item
Description
Target data
TASK1
TASK1 measurement results
TASK2
TASK2 measurement results
TASK3
TASK3 measurement results
TASK4
TASK4 measurement results
TIMING
TIMING input signal (parallel I/O)
ZERO
ZERO input signal (parallel I/O)
BUSY
BUSY output signal (parallel I/O)
ENABLE
ENABLE output signal (parallel I/O)
HIGH
HIGH output signal (parallel I/O)
PASS
PASS output signal (parallel I/O)
LOW
LOW output signal (parallel I/O)
Item
Setting item
Range
Description
Sampling setting
Data interval
0 to 65535
Set the sampling interval for the target data.
You can also specify the timing (start trigger, end trigger) for the graph display.
Note
Summary of Contents for ZW-C1*AT
