Offline Debugging of the Sensor Control Program and Sensor Operation
266
ZW User's Manual
2
Select the ZW that was added to the Edit Network Configuration Tab Page and change the node
address of the ZW to the node address that is set on the ZW hardware switches.
Setting Up the ZW
Set up the inspections in the ZW, e.g., set the inspection items.
Executing the Simulation
1
Double-click the ZW that was added to the
Edit Network Configuration Tab Page.
The ZW Setup Pane is displayed for the Edit
Pane. Make all of the required settings.
1
Write and build the user program that will
operate the machine.
Refer to the
Sysmac Studio Version 1 Operation
Manual
(Cat. No. W504) for details on
programming.
2
Open the Edit screen.
Right-click [(Sensor model)] in the Edit network
configuration Tab page and select [Edit].
Summary of Contents for ZW-C1*AT
