Installation
38
ZW User's Manual
Connecting Fiber Cable
Connect the fiber cable on the Sensor Head to the Sensor Head connector on the Sensor Controller as follows:
1
Remove the protective caps from the Sensor Controller's fiber connector and the fiber cable.
Do not discard but keep the protective cap handy.
2
Mate the convex section on the fiber cable with the groove on the fiber connector and turn the
threaded section clockwise while pushing in (see figure 1).
In the "No good" status in figure 2 and figure 3, optic signals cannot be transmitted and correct
measurement is not possible. Always check that the system is in the "Good" status.
Protecti
v
e cap
Fi
b
er connector
Protecti
v
e cap
Fi
b
er ca
b
le
Important
Fiber cable
Fiber
connector
Groove
Convex
section
Threaded
section
(Figure 2)
(Figure 3)
(Figure 1)
Good
No good
Good
No good
Summary of Contents for ZW-C1*AT
