68
Common Setting Operations
Section 4-2
4-2-4
Setting Numeral Memory Tables
This section describes how to set the initial values, and data area referenced in the
PC, for numeral memory tables.
The number of numeral memory tables is determined by the “PT Type” setting, as
follows:
NT20S, NT20M:
128 tables
NT600S, NT600M:
256 tables
NT30, NT30C, NT612G, NT610C:
1,000 tables (The number can be changed to 512 even
when using direct connection, in accordance with the sys-
tem memory).
Reference:
When using an NT30, NT30C, NT612G, or NT610C, numeral memory table num-
bers 247 through 255 are used for the clock function and, therefore, setting opera-
tions cannot be set for them.
[When not using direct connection]
[When using direct connection]
S
No.:
Numeral table number
S
Init Val:
Initial value
Summary of Contents for NT - SUPPORT TOOL 07-1995
