Omron NT - SUPPORT TOOL 07-1995, Operation Manual

Page: 35 / 225

16
Basic Operating Procedures
Section 2-2
2-2-6 Selecting Numbers and Codes
The support tool allows simple selection of the following numbers and codes.
S
Screen numbers
S
Numeral table numbers
S
Character-string memory table numbers
S
Bit memory table numbers
S
Image codes
S
Library codes
S
Extended I/O input terminal numbers (*)
S
Extended I/O output terminal numbers (*)
(*) Only number specification using the [Tab] key can be used for these.
When a screen that displays a list of numbers or codes is displayed, the key opera-
tions indicated below can be used:
[Shift] + [ ] key : Moves the bar cursor from the position where it is currently
located to the previous number or code for which there is
data.
[Shift] + [ ] key : Moves the bar cursor from the position where it is currently
located to the next number or code for which there is data.
Example:
Assume that the bar cursor is on screen number 6 and there is data only for screen
numbers 2, 4, and 10:
[Shift] + [ ] key : The bar cursor moves to screen number 4.
[Shift] + [ ] key : The bar cursor moves to screen number 10.
If now, while the bar cursor is at screen number 10, [Shift] + [ ] is pressed again,
the bar cursor will move full cycle to screen number 2.