186
Preparation and Procedure for Data Communication with the PT
Section 7-1
Communication Speed
Select the communication speed for communication with the PT by setting “Com-
munication Mode” on the “Tool Settings” screen.
Setting “Hspeed” for this setting will enable high-speed data transfer.
If the communication environment is unfavorable or communication errors occur,
set “Stndrd” for low-speed communication so that the data will be communicated
reliably.
Reference:
Presented below are OMRON’s measurements of the time taken to transfer the
entire capacity of the image memory when transfer is in the “Hspeed” mode. Use
these as a guide to data communication times.
S
When using a capacity of 512 Kbytes:
5 min. 5 sec.
S
When using a capacity of 1 Mbyte:
9 min. 30 sec.
Communication in the “Stndrd” mode takes approximately twice as long as com-
munication in the “Hspeed” mode.
Tool Settings When Communicating With an NT20S or NT600S
When using an NT20S or NT600S, the combination of tool settings that allows
communication with the support tool depends on which model is used.
Set the tool settings for communication with an NT20S or NT600S correctly by re-
ferring to the table below.
S
When using an NT20S
Tool Settings
Model
“PT Type”
Setting
Direct Access
NT20S-ST121
NT20S-ST121-V1/
ST122-V1
NT20S-ST128
20M
Not used
x
x
x
20S
Not used
x
x
f
20M
Ver.4
f
f
in NT20M com-
patible mode
x
20S
Ver.4
x
f
x
20S
Ver.5
x
f
x
f
: possible x: not possible
S
When using an NT600S
Tool Settings
Model
“PT Type”
Setting
Direct Access
NT600S-ST121/
ST211
NT600S-ST 121-V1/
ST211-V1 direct
connection
NT600S-ST121-V1/
ST211-V1 direct
connection
600M
Not used
x
x
x
600S
Not used
x
x
f
600M
Ver.4
f
in NT600M
compatible
mode
f
in NT600M
compatible mode
x
600S
Ver.4
f
f
x
600S
Ver.5
x
f
x
f
: possible x: not possible
Summary of Contents for NT - SUPPORT TOOL 07-1995
