Omron NT - SUPPORT TOOL 07-1995, Operation Manual

Page: 187 / 225

168
Images
Section 5-2
Procedure 1. Select “LOUPE” from the image editing menu.
2. Carry out drawing in dot units.
3. Press the [Esc] key to quit the enlarged display.
Drawing Operations Using the Image Editing Menu
Functions are selected from the image editing menu in order to carry out drawing.
The following graphic elements can be used:
Points, lines, locus, circles, ellipses, squares
In the case of circles, ellipses and squares, it is also possible to select normal or
inverted displays.
When using an NT30C or NT610C, the color can also be specified.
Ellipses can only be drawn as images.
S
Points
Key operation: Press the key.
Mouse operation: Click the left mouse button.
S
Lines
Key operation: Press the key at the start point and end point.
Mouse operation: Click at the start point and end point.
S
Locus
Key operation: Locus drawing is not possible with key operations.
Mouse operation: Drag the mouse while holding down the left mouse button.
S
Circles/ellipses
Key operation: Press the key at diagonally opposed points to draw a circle
or ellipse that just makes contact with the inside of the rectan-
gle defined by these points.
Mouse operation: Click at diagonally opposed points to draw a circle or ellipse
that just makes contact with the inside of the rectangle defined
by these points.
S
Squares
Key operation: Press the key at the diagonally opposed points.
Mouse operation: Click at the diagonally opposed points.