Omron NT - SUPPORT TOOL 07-1995, Operation Manual

Page: 190 / 225

171
Library Data
Section 5-3
5-3 Library Data
Two or more graphics can be registered together as library data. Complex graph-
ics need only be created once, after which they can be used repeatedly.
Library data can only be used when using an NT30, NT30C, NT610G, or NT610C.
The following codes can be used for library data:
FA20 to FAFF, FB20 to FBFF, FC20 to FCFF, FD20 to FDFF (896 items).
5-3-1 Procedure for Library Data Creation
Library data is created by registering two or more graphics created on the library
editing screen collectively under one code. Up to 896 library data can be regis-
tered.
Procedure 1. Select “Image & Lib” on the “Screen Selection” screen.
2. Locate the cursor at the code of the library data to be created and press the
key.
"
Use [Shift] + [ ] or [Shift] + [ ] to move the bar cursor to the previous or next
code for which there is data.
Use the [ ]/[ ] keys to switch between image and library data.
Existing comments can be changed by pressing the [F6] (Commnt) key and
inputting the required characters.
Press the [Tab] key to display the code input field.
The data in a code for which data already exists can be deleted by pressing the
[F1] (Delete) key and then specifying that code.
The data in a code can be copied by pressing the [F2] (Copy) key and then
specifying the copy source code and the copy destination code.
3. Draw the library data on the screen using the mouse and keys (see “Library
Editing Operations” on the next page).
4.
Press the [Esc] key to quit library data creation.
On quitting, specify “Confirm”.
5. Specify the area that is to be saved as the library data.
Regardless of the environmental settings (tool settings for the “Edit” screen),
only graphics that are completely contained within the specified area will be
registered.
Locate the cross-hair cursor at the start point and end point of the area and
press the
key at each.
6. Input a comment.
This is a memo that indicates the nature of the library data.