86
Creating Fixed Displays
Section 4-3
4-3-4
Creating Squares
This is the procedure for drawing squares.
Procedure 1.
Select “FIX DSP” from the initial editing menu.
The fixed display menu will be displayed.
2.
Select “SQUARE” from the fixed display menu.
3.
Select the display attribute with “Detail”.
The selectable options are “normal”, “inverted”, “flashing” and “spot”.
4.
If using an NT30C or NT610C, specify the line color.
5.
Press the
key with the cursor on “Exec”
6.
Draw the square.
1) Press the
key at the start point.
2) Locate the cursor at the end point (diagonally opposite point) and press the
key.
End point
Start point (
)
(
)
"
Pressing the [Esc] key before the end point has been set aborts the drawing.
7.
Press the [Esc] key to quit square drawing.
Deleting Squares
Procedure 1.
Select “SQUARE” from the fixed display menu and then press the [F1] (De-
lete) key.
A
j
mark will be displayed at the start point of the square.
2.
Locate the cursor at the
j
mark of the square to be deleted and press the
key.
3.
Check the message and then press the
key; the square will be deleted.
To abort deletion, press the [Esc] key.
Summary of Contents for NT - SUPPORT TOOL 07-1995
