Omron NT - SUPPORT TOOL 07-1995, Operation Manual

Page: 203 / 225

184
Preparation and Procedure for Data Communication with the PT
Section 7-1
7-1 Preparation and Procedure for Data Communication
with the PT
Screen data created using the support tool, and mark and memory table informa-
tion, etc., can be transferred to the PT data memory. It is also possible to receive
various types of data and display history records from the PT and save them.
Caution: When using an NT30, NT30C, NT612G, or NT610C, data is communicated in file
units. Communication in screen units is not possible.
Connection to the PT Connect the PT and personal computer with an RS-232C connecting cable.
Connect this cable to the tool interface at the PT side and to the RS-232C interface
at the personal computer side. Note that this connection with the PT is established
only for data communication; it is not usually necessary to make this connection.
S
Connection method
Make the connection with the RS-232C cable in the manner shown below.
Connection to an NT20M/NT20S
Connection to an NT2000M