NEAX2400 IPX Feature Programming Manual
Page 374
NDA-24297, Issue 1
F-36
FCCS Networking via IP
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
The data programming for Point-to-Point connection and Point-to-Multipoint connection is identical.
STEP 1:
ASYDL
- Provided that the IPTRK circuit card is equipped in the node within the FCCS network,
NDM data broadcasting is not to be executed. Therefore, when the IPTRK card is used in the FCCS
network, perform the following data assignment at the NCN. SYS 1, Index 534, b7-1 (NDM data
individual broadcasting from NCN to each LN).
STEP 2:
ACRD
- Assign Route Class Data of Speech routes. It is not required to assign the signal route data.
The IPTRK card assigned by the AFCH command is used as the FCCS signal channel controlling card.
STEP 3:
ACTK
- Assign the connection trunk data of the IPTRK circuit card. It is not required to assign the
trunk data for D-channel.
STEP 4:
MBCT
- Un-busy the connection trunk data assigned in the previous step using the MBCT command.
STEP 5:
AFCH
- Assign FCH number (FCHN) to each IPTRK card which is used as the FCCS signal
controlling card.
STEP 6:
AETH
- Assign the FCCS route data.
FPC:
Assign FPC number (1-253) of the destination node
FCHN:
Assign the FCH number specified in STEP 5
C_RT:
Connection Route Number of Speech Channel (1-1023)
DST_IP:
Assign IPTRK IP address of the destination node
NEXT_IP: Assign IPTRK IP address of the next node (node to be passed to)
For further information, see the IPTRK Circuit Card System Manual.
STEP 7:
ACAN
- Assign the Fusion Connection Index Code (FCIC) to the self-node FPC.
FPC:
Assign FPC number (1-253) of the self-node
FCIC:
Assign unique fusion CICs in the self-node
C_LENS:
Assign IPTRK LENS data (B-ch data) specified in STEP 3
STEP 8:
AFRT
- Set Connection Route Numbers of the Speech Channels for the FCHN which was assigned in
STEP 5.
FCHN:
Assign FCHN, specified in STEP 5
C_RT:
Assign Connection Route of Speech Channels, specified in STEP 2
STEP 9:
AGIP - Assign IP addresses of the IPTRK card and its connected router.
Kind:
Select IPTRK (FCCS)
IPTEN:
Assign the 1st LEN of IPTRK accommodated HW block
IPTK_IP:
Assign IP address of the IPTRK card
DG_IP:
Assign IP address of the router
ARP:
Select DIX
CLINK_NUM: Default value
SLINK_NUM: DEfault number
NETMSK:
Assign IP address of the Net MAsk
MULT:
Select Point-to-Point
QoS1:
0-7
QoS2:
0-7
NETID:
0-15
