NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 137
Call Forwarding - All Calls - D
term
C-5D
Programming (cont’d)
System Data 1, Index 69, Bit 1 (Bit 2 - Burst of Tone for Recall). A burst of ringback tone to alert the
person receiving a CALL FORWARDING - ALL CALLS - D
term
call. In service? 0/1: No/Yes.
Normally assigned as data “0”.
System Data 2, Index 6, Bit 4. Enables station set for CALL FORWARDING-ALL CALLS-D
term
to
be allowed to use phones normally. If data “0” is assigned, the station will only be able to call the
Attendant Console. Assign on a per-tenant basis.
STEP 2:
ANPD
- Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 3:
ASPA
- Assign an access code to CALL FORWARDING-ALL CALLS-D
term
entry SID = 8, and to
CALL FORWARDING-ALL CALLS-D
term
cancel SID = 9. Assign Connection Status Index (CI) for
Normal (N) service.
STEP 4:
ASFC
- Assign a Service Feature Class that allows SFI = 7 to stations that will activate CALL
FORWARDING - ALL CALLS-D
term
.
STEP 5:
AKYD
- For D
term
sets, CALL FORWARDING-ALL CALLS-D
term
may be assigned to a
programmable line/feature key. Assign Type:Function:CALL FORWARDING-ALL CALLS [2].
STEP 6:
ADSL
- Assign SN=1 (Originating) and FKY=2 (Call Forwarding All Calls; FDA).
This command is required only for assigning the function to each soft key.
STEP 7:
ATNR
- Allow tenant-to-tenant connection for Inter and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this service feature to be set by the Attendant Console, assign Inter an
Intra-Tenant connection TRI = 3, via the Attendant Console. Also allow TRI = 0, station-to-station
calling.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note 1
STEP 1:
ASYDL
- This data must be assigned to the node set Call Forwarding service.
System Data 1, Index 640: Assign the Fusion Point Code (FPC) of the node providing the attendant
console.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
Note 2:
The data of the ASFC command is assigned to the node set Call Forwarding service.