NEAX2400 IPX Feature Programming Manual
Page 444
NDA-24297, Issue 1
L-10
LCR - Time Of Day Routing
Programming (cont’d)
STEP 2:
ASDC
- If 6-digit translation is required where both the Area and Office codes must be examined, this
command must be used. The system is automatically set as an Allow table. To create a Deny table,
assign the following:
OFFICE:
0
EFFECT:
1
Program the type of route as PFX (Prefix, Foreign Exchange, FX) or as SCC (Special Common
Carrier).
Choose TDC PTN, Time-of-Day Pattern. Go to ATCP.
Choose the OPR number this six-digit table will serve.
Choose the RA (Route Advance) Number to specify the route in the OPR.
When assigning for PFX, each NXX is assigned as the following:*
EFFECT:
0 = Allow, No 1 + dialing
EFFECT:
1 = Allow with 1 + dialing (system adds the 1)
EFFECT:
2 = Not Allowed
When assigning for SCC, each NXX is assigned as the following:
EFFECT:
0 = Restricted
EFFECT:
1 = Allowed
EFFECT:
2 = Not Used
Note:
*PFX, EFFECT: 1 is presently not available. Use the AADC command to add the required digits.
STEP 3:
ATCP
- A maximum of eight Time-of-Day Pattern changes (0-7) are available, whereby the system
will refer to different OPR assignments as a function of time. As a result, different routes will be listed
per OPR and will require different assignments in ASDC.
Assign the following:
Time Setting
TO:
FROM: (In military time, and only on the half hour and hour)
PATTERN NUMBER: (0-7).
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
AOPRL
- The AFRS command designates the dialing sequence and the OPR to be selected. The
AOPR defines the logical routes and in what order these logical routes will be selected. Assign the
following:
TDPTN - Time-of-Day Pattern Change. If for an AFRS assignment, different OPRs will be required as
a function of time; designate 1-7 to which Time-of-Day Pattern Change Number (TDC NO) this OPR
is assigned.
OPR No. (OPR) - Outgoing Pattern Route. The number referenced in AFRS, consisting of a series of
routes to be chosen based on number dialed.
Route Advance Number (RA) - The order in which a route is selected. (0-7).
Route Advance End Display (E) - The last route in the route advance group. Indicate last route with
data “0”.
