NEAX2400 IPX Feature Programming Manual
Page 794
NDA-24297, Issue 1
V-3D
Volume Control - D
term
V-3D
Volume Control - D
term
General Description
This feature is used for controlling the volume of a D
term
set’s built-in speaker and receiver.
Operating Procedure
1.
The D
term
set is equipped with a sliding volume control knob located in the front, beneath the dial pad.
Volume can be increased by moving the control to the right, and decreased by moving it to the left.
2.
The ringing volume is controlled by a switch on the underside of the D
term
. It is marked RING and located
directly below the LCD Display Panel. The ringing volume is increased by moving the switch to the right
and decreased by moving the switch to the left.
3.
The ringing tone can be set to one of three distinct tones, using switch settings “1”, “2”, or “3”, depending
on user preference. Each switch setting produces a separate distinct ringing tone.
Setting “1” produces the lowest.
Setting “2” produces a medium.
Setting “3” produces the highest.
To control the ringing tone, there is a switch located underneath the D
term
. It is opposite the Transfer Key,
and is labeled RINGING TONE. It has switch settings marked 1, 2 and 3.
For D
term
Series E
1.
The D
term
is equipped with two control buttons located on the top front of the phone. Volume can be
increased by pushing the right control button while off-hook. Volume can be decreased by pushing the left
control button while off-hook.
2.
The ringing volume is also adjusted by the same two control buttons. Ringing volume by pushing the right
control button while the D
term
is ringing. Decrease the ringing volume by pushing the left control button
while the D
term
is ringing.
3.
The ringing tone can be set to one of four distinct ringing tones by performing the following: Press the
feature key + 3. Each time this is performed, one of the four patterns is selected.
Service Conditions
Ringing, Recall Ringing, and Voice Call Signal Tone are not controlled by VOLUME CONTROL.
Programming
No programming is required.
