NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 1037
Toll Restriction - 3/6-Digit - CCIS
T-26
Programming (cont’d)
DC:
000000
RES:
1 (Allowed)
This will restrict 976 and allow every other Office Code.
STEP 6:
ARRC
- This command provides trunk-to-trunk connection abilities according to the requirements of
the system. The applicable trunk-to-trunk will be those connections provided by parameter ARI-D-
RES direct connection. For example, REMOTE ACCESS TO THE SYSTEM [R-2] and TANDEM
SWITCHING OF TIE TRUNKS - 2/4 WIRE [T-1].
ICRT:
Incoming Route Number
OGRT:
Outgoing Route Number
ARI-A-RES:
Alternative Route Index
This allows/restricts trunk-to-trunk and tandem connection via the ATTENDANT CONSOLE [A-3]
(and stations).
D:This allows/restricts trunk-to-trunk and tandem connections via direct dial access from a
station.
RES:
Restriction Data
Attendant Console (ARI-A-RES)
0:
Alternate routing is restricted.
1:
Alternate routing is allowed.
Dial Access (ARI-D-RES)
0:
Alternate routing is restricted.
1:
Alternate routing is allowed.
2:Toll Restriction is required.
STEP 7:
ATDP
- When TOLL RESTRICTION is required for trunk-to-trunk connections, ATDP will provide
all digit information. Up to 11 digits may be listed as being allowed for a specific trunk-to-trunk
connection. TDI = 2 should not be assigned because AARP cannot be used for Tandem connections.
Example 6 - Trunk to Trunk Connection
(Allow all Local Calls)
ATDP Command -
TDM/OG: T (Tandem Connection)
ICRT:
2
OGRT:
1
DC:
92
TDI:
1 (Connection is Allowed)
Repeat these same assignments for Digit Codes (DC) 93 - 99 to allow all local office codes.
Notice that assignments for digit codes 90 and 91 which cover operator calls and all 1 + Area Code
calls are not assigned. Digit Codes (DC) which are not assigned are automatically restricted.
Example 7 - Trunk to Trunk Connection
(Allow Limited Area Codes)
ATDP Command -
TDM/OG: T (Tandem Connection)
ICRT:
2
OGRT:
1
DC:
92 TDI:
1 (Connection is Allowed)
Repeat these same assignments for Digit Codes (DC) 93 - 99 to allow all local office codes.
To allow Area Codes 718, 212, 201, & 914 repeat the ATDP command for the following Digit Codes:
DC:
91718 TDI:
1 (Allow)
DC:
91212 TDI:
1 (Allow)
DC:
91201 TDI:
1 (Allow)
