NEC N8100-14522F, User Manual

Page: 83 / 320

Configuring Your Server 4-15
Peripheral Configuration
IMPORTANT:
Note that the interrupt and/or base I/O address are not
overlapped with others. If the value set for the interrupt or base I/O
address is used in another resource, the yellow asterisk (*) appears.
Reset any item with the yellow asterisk properly.
Option Parameter Description Your Setting
Serial Port B Disabled
[Enabled] Selects whether serial port B is enabled or
disabled.
Base I/O
address 3F8
[2F8]
3E8
2E8 Selects the base I/O address for serial port
B.
Interrupt [IRQ 3]
IRQ 4 Selects the interrupt for a serial port B.
USB Controller [Enabled]
Disabled Selects the USB controller is enabled or
disabled.
USB 2.0 Controller Disabled
[Enabled] Selects the USB 2.0 controller is enabled or
disabled.
Parallel ATA Disabled
[Enabled] Selects parallel ATA controller on mother
board is enabled or disabled.
Serial ATA Disabled
[Enabled] Selects whether the serial ATA controller on
mother board is enabled or disabled.
SATA Controller
Mode Option Compatible
[Enhanced] Selects an operation mode of onboard
SATA controller. Displayed only when Serial
ATA is enabled.
Compatible mode:
SATA drives are automatically detected
and controlled in legacy mode.
Enhanced mode:
SATA drives are automatically detected
and controlled in native mode.
Native Mode
Operation AUTO
[Serial ATA] –
SATA AHCI Disabled
[Enabled] Selects whether AHCI (Advanced Host
Controller Interface) is enabled or disabled.
Displayed only when [Enhanced] is selected
for [SATA Controller Mode Option].
SATA RAID Disabled
[Enabled] When set to [Enabled], this menu appears if
RAID configuration jumper switch is set to
[RAID enable] position. See Chapter 4 for
details.
[ ]: Factory-set