NEC N8100-14522F, User Manual

Page: 201 / 320

Troubleshooting 8-11
Error
code
Error message Recommended Action
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
0BB0 SMBIOS – SROM data read error.
0BB1 SMBIOS – SROM data checksum bad.
Contact your service representative.
8068 Unsupported Processor Speed detected on
CPU Slot 1
8069 Unsupported Processor Speed detected on
CPU Slot 2
8100 Memory Error detected in DIMM group #1.
8101 Memory Error detected in DIMM group #2.
8102 Memory Error detected in DIMM group #3.
8103 Memory Error detected in DIMM group #4.
8104 Memory Error detected in DIMM group #5.
8105 Memory Error detected in DIMM group #6.
Contact your service representative to
replace the DIMM in the relevant group.
8150 NVRAM Cleared by Jumper Start SETUP and provide setting again.
8151 Password Cleared by Jumper Start SETUP and set password again.
8160 Mismatch Processor speed detected on
Processor 1.
8161 Mismatch Processor speed detected on
Processor 2.
Contact your service representative.
None Expansion ROM not initialized – PCI Mass
Storage Controller in slot n (n: slot number) Disable initialization of the optional device
expansion ROM by using the BIOS SETUP
utility (see Chapter 4).
H/W Configuration of BMC is corrupted.
!! Update BMC F/W Configuration by
configuration tool !!
!! Refer to BMC configuration manual !! Use the NEC EXPRESSBUILDER to
configure the remote management card
(see Chapter 6).