NEC N8100-14522F, User Manual

Page: 204 / 320

8-14 Troubleshooting
Messages displayed on lower line (BMC message)
On-screen message Description Action
Proc1 VccpAlm XX Voltage alarm occurred
Proc2 VccpAlm XX
Contact your service
representative.
BB P_VTT Alm XX
BB +1.2v Alm XX
BB +1.5v Alm XX
XX=09: high voltage (fatal)
BB +1.8v Alm XX XX=07: high voltage (warning)
BB +3.3v Alm XX
BB +3.3vs Alm XX
XX=02: low voltage (warning)
BB +5.0v Alm XX XX=00: low voltage (fatal)
BB +5vs Alm XX
BB +12v Alm XX
VBAT Alm XX
BB Temp Alm XX
Mother board thermal error occurred.
XX=09: high voltage (fetal)
XX=07: high voltage (warning)
XX=02: low voltage (warning)
XX=00: low voltage (fetal) Fan may be faulty or clogged
with dust.
Contact your service
representative.
Proc1 Therm % XX
Proc2 Therm % XX Processor thermal error occurred.
XX=09: high voltage (fetal)
XX=07: high voltage (warning)
DUMP Request ! Dump switch is pressed. Wait for completion of
memory dump collection.
OS shutdown Alm OS stop error occurred. Take note of on-screen
message, wait for completion
of memory dump collection,
then contact your service
representative.
Power On Cnt Alm Power supply failure occurred.
240VA Power Down
Contact your service
representative.
Proc Missing Processor is not found.
Proc1 T-Trip
Proc2 T-Trip Thermal Trip occurred on processor #1 or
#2. The system is forcibly turned off.
Processor 1 IERR
Processor 2 IERR IERR occurred on processor #1 or #2.
SMI timeout SMI timeout occurred.
WDT timeout Watchdog timer timeout error occurred.
SF X Alarm A fan alarm occurred.
X: 3 to 12 Fan may be faulty or clogged
with dust.
Contact your service
representative.
HDD0 Fault
HDD1 Fault
HDD2 Fault A hard disk drive error occurred. 1. Check if the hard disk
drives are properly
installed.
2. Replace the failed hard
disk drive and perform
rebuilding.
3. If the same error occurs,
contact your service
representative.