NEC N8100-14522F, User Manual

Page: 24 / 320

1-8 Notes on Using Your Server
Installation, Relocation, Storage, and Connection
WARNING
Disconnect the power cord(s) before installing or removing the server.
Make sure to power off the server and disconnect the power cord(s) from a
power outlet before installing/removing the server. All voltage is removed only
when the power cords are unplugged.
CAUTION
Do not install the server in any place other than specified.
Do not install the server in the following places or any place other than
specified in this manual. Failure to follow this instruction may cause a fire.
■
a dusty place
■
a humid place such as near a boiler
■
a place exposed to direct sunlight
■
an unstable place
Do not use the server in the place where corrosive gases exist.
Make sure not to locate or use the server in the place where corrosive gases
(sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone,
etc.) exist.
Also, do not set it in the environment where the air (or dust) includes
components accelerating corrosion (ex. sulfur, sodium chloride) or conductive
metals. There is a risk of a fire due to corrosion and shorts of an internal
printed board.
Pay attention not to drop the server.
Firmly hold the bottom of the server when installing it in the rack.
The rack mount bracket has no stopper or lock mechanism to prevent the
server from falling down. Failure to follow this instruction may cause personal
injury.
Do not leave the device being pulled out from the rack.
Do not work with the server with the device being pulled out from the rack.
The rack mount bracket has no stopper or lock mechanism to prevent the
server from falling down. Failure to follow this instruction may cause personal
injury.
Do not install the server on a rack with leaving covers removed.
Do not install the server on a rack with the cover being removed. Failure to
follow this instruction may reduce the cooling effect in the server to result in
some malfunction and/or dusts to enter the server to result in a fire or electric
shock.
Do not pinch your finger with rails or other components.
Note sufficiently that your fingers may not be caught between a rail and
another mechanical part or cut by a rail at installation or removal of the server
from the rack.