NEC Express 5800 120Eg, User Manual

Page: 256 / 292

120Eg User Guide - Appendix D
D - 31
Memory Dump (Debug Information)
This section describes the procedures for collecting memory dump (debug information)
in the server.
Caution
Cautions for the Memory Dump
■
The staff of maintenance service representative is in charge
of collecting memory dump. Customers need only to specify
the memory dump.
■
If any trouble occur after specifying the process below, the
message to inform that the system is in short of virtual mem-
ory may appear, but continue to start the system. If you re-
start the system in such case, memory dump may not be
stored correctly.
Follow the procedure below to specify.
1. Point to [Settings] in Start menu and click [Control Panel].
The [Control Panel] dialog box appears.
2. Double-click [System].
The [System Properties] dialog box appears.
3. Click [Advanced].
4. Click [Startup and Recovery].
5. Enter the location to write the debug information to the text box.
e.g. Write the debug information in D drive with the file name
"MEMORY.DMP".
D:\MEMORY.DMP
Caution
■
To specify "Complete Memory Dump" to write the debug
information is recommended. If the mounted memory size is
larger than 2 GB, "Complete Memory Dump" cannot be
specified so that specify "Kernel Memory Dump" instead.
■
Specify the drive where there is a free area more than the
size of "the memory capacity mounted on Express
12 MB".
■
In case the mounted memory size exceeds 2 GB due to the
added memory, change the write debugging information to
[Kernel Memory Dump] before adding memory. The size of
debugging information (memory dump) to be taken also