NEC Express 5800 120Eg, User Manual

Page: 204 / 292

120Eg User Guide - Problem Solving
5 - 36
Recovery for Windows 2000 System
If any file necessary for running the OS is damaged, use the following procedures to
recover the system.
Caution
■
After recovering the system, see “Updating the System” on
page D-18 and be sure to update the system.
Also on Windows 2000, you need to update all the drivers
after the system update. For more information, see
“Installing and Setting Device Drivers” on page D-11 .
■
If the hard disk can not be recognized, you can not recover
the system.
Follow the procedure below and use the information in the disk, not system recovery
disk, to recover the system.
1. Turn on the power of the system.
2. Insert Windows 2000 CD- ROM into the CD-ROM drive of your server.
3. Press the RESET switch or press
Ctrl
,
Alt
, and
Delete
to reboot the server.
(You may also turn off and then on again to reboot the server.)
4. Press F6 while the message "Setup is inspecting your computer's hardware
configuration..." is displayed at the upper part of the screen.
Note: Nothing is changed on the screen through F6 is
pressed.
5. Press
S
when the following message appears:
Select [Other] and press Enter .
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an
adapter.
Currently, Setup will load support for the following mass storage devices.