120Eg User Guide - Problem Solving
5 - 37
6.
Insert Windows 2000 OEM-DISK for NEC EXPRESSBUILDER into the
floppy disk drive and press
Enter
.
7.
If the optional board or HostRAID is installed, select the proper disk controller
and press
Enter
.
■
Windows Promise FastTrak S150 SX4
Controller
Press
R
to select the recovery option.
8.
Select the keyboard.
9.
If you are requested, press
R
to select system recovery procedure.
10.
If you are requested, select either of the procedure below:
[Manual Recovery] (Press
M
)
Do not select this option unless you are a high-level user or a system
administrator. If you use this option, you can recover the problems of
system files, partition boot sector, and start-up environment.
[Quick Recovery] (Press
F
)
This option is very easy to use and the user does not need to do anything
during the procedure. If you select this option, the system recovery disk
program starts to recover the problems concerning system files, partition
boot sector of system disk, and start-up environment (if multiple operating
systems are installed on the system).
11.
Follow the instruction displayed on the screen, and then press
L
at the screen
which request you to insert system recovery disk. The system will be restarted
once.
Note:
Starts the procedure without system recovery disk.
12.
Repeat steps 1 to 10.
The recovery procedure will be started.
During the recovery, the missing files and the damaged files are replaced either
to the files in C:\ I386 folder of hard disk or the files in systemroot\ Repair of
the system partition. These replaced files do not reflect the changes of the
configuration after the setup at all.
13.
Follow the instruction displayed on the screen.
If you take a note of any file name in which trouble is detected during the
procedure, it is useful to diagnose how the system has been damaged.
14.
Terminates the procedure if the recovery is successful.
You can verify that the replaced files are correctly copied to the hard disk if the
computer is restarted normally.
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
* Press ENTER when ready.
Summary of Contents for Express 5800 120Eg
