NEC Express 5800 120Eg, User Manual

Page: 111 / 292

120Eg User Guide - Upgrading Your System
4 - 9
Installing a 5.25-Inch Media Device
To install a 5.25-inch media device, perform the following procedures:
1. Observe the safety and ESD precautions listed under
“Safety Notices” on page 1-
xviii
and
“Static Precautions” on page 4-2
.
2. Prepare your system for upgrade. See
“Preparing Your System for Upgrade” on
page 4-3
.
3. Remove the side cover as described in
“Removing or Installing the Side Cover” on
page 4-4
.
Caution
Observe static precautions. Use an antistatic wrist strap.
4. Remove the dummy cover from the bay where you are installing a media
device. The dummy cover is released by removing the two screws holding it in
place (see "Figure 4 - 6: Removing the Dummy Cover" on page 4-9). Save the
dummy cover and screws for future use.
Note:
When installing a full-height device, remove two
dummy covers.
Figure 4 - 6: Removing the Dummy Cover
5. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
6. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
7. Attach the mounting rails to the device with the four screws that come with the
device, as shown in "Figure 4 - 7: Attaching the Device Mounting Rails " on
page 4-10.