120Eg User Guide - Upgrading Your System
4 - 12
Figure 4 - 9: SCSI Interface Cable
12.
Connect the power cable to the device.
13.
Reinstall the side cover on the system chassis. See
“Removing or Installing the
Side Cover” on page 4-4
.
14.
Plug in the system power cord(s), and turn on the system.
Removing a 5.25-Inch Media Device
1.
Perform steps 1, 2, and 3 of
Installing a 5.25-Inch Media Device
described
earlier in this chapter.
2.
Disconnect the SCSI or IDE interface cable and voltage cable from the rear of
the device you are removing.
3.
Remove the two screws securing the device to the removable media device
bay. See "Figure 4 - 8: Securing a Removable Media Device" on page 4-11.
4.
Slide the removable media device out of the device bay and set it down on an
antistatic surface.
Caution
Observe static precautions. Use an antistatic wrist strap.
5.
Remove the screws securing the device mounting rails to the device and set the
rails and screws aside for future use. See "Figure 4 - 7: Attaching the Device
Mounting Rails " on page 4-10.
A
System board SCSI connector
B
Not used
C
5.25-inch device bay SCSI connector for slot 1
D
5.25-inch device bay SCSI connector for slot 2
E
Terminator
A
B
C
D
E
A
A
B
C
D
E
Summary of Contents for Express 5800 120Eg
