120Eg User Guide - Setting Up the System
2 - 24
■
Some system configurations may display the message
"Press Any Key" to prompt a key entry. This message is
driven by BIOS of an installed optional board. Make sure to
read the manual that comes with the optional board before
any key entry.
■
Powering on the server, after you installed or removed an
optional PCI board or moved it to another slot, may display
the message that indicates incorrect board configuration and
suspend POST.
In such a case, press
F1
to continue POST. Board configu-
ration can be made using the utility described later.
1.
After a few seconds from power-on, POST starts checking the memory. The
count message of the basic and expansion memory appears at top left on the
display unit screen. The memory check may takes a few seconds to complete
depending on the memory size of the Express server. Also, it may take
approximately one minute for the screen display to appear after rebooting the
server.
2.
Some messages appear upon completion of the memory check. These
messages appear to indicate that the system has detected the CPU, keyboard,
and mouse.
3.
After a few seconds, POST displays the following message prompting you to
launch the BIOS setup utility, SETUP, stored in the system memory of the
server. This message appears at bottom left on the screen.
Launch the BIOS SETUP utility when you need to change the settings to meet
the requirements for the server. As long as the above message is not displayed
with an error message, you don't have to launch the utility. (Ignore the
message. POST will automatically proceed.)
To launch the SETUP utility, press
F2
while the above message is displayed.
See
“BIOS Setup Utility” on page 3-3
for setup and parameters.
The server automatically restarts POST all over again when you exit the
SETUP utility.
Press
F12
to start the operating system from the network drive.
4.
If the server has an optional RAID controller or SCSI card, POST displays the
message prompting you to launch the RAID configuration utility and the disk
array BIOS setup utility.
Refer to the manual supplied with the disk array controller for detail
instructions.
POST will automatically proceed a few seconds later.
Press <F2> to enter SETUP or Press <F12> to Network
Summary of Contents for Express 5800 120Eg
