NEC Express 5800 120Eg, User Manual

Page: 133 / 292

120Eg User Guide - Upgrading Your System
4 - 31
■
While holding the drive carrier align it so that it engages the guide rails in
the drive bay. See "Figure 4 - 22: Installing the Carrier into the Bay" on
page 4-28.
■
Push the carrier handle up until the handle clicks and locks in place.
5. Close the front door on the system. If necessary, configure the system as
described in
“BIOS Setup Utility” on page 3-3
.
Note:
In the disk array configuration, the auto rebuild
function can be used. The auto rebuild function can record the
information saved in a defected hard disk drive into the new
replaced disk drive in order to recover the server to the state
before the fault occurrence.
The auto build function is valid for disk arrays set to RAID1,
RAID5, or RAID0+1.
The auto rebuild is automatically started by hot-swapping a
defected hard disk drive. During the auto rebuild, the hard disk
drive individual SCSI or S-ATA drive activity/fault LED is lit
green or flashing amber.