13 - 9 13 - 9
MELSEC-Q
13 TROUBLESHOOTING
Error
code
Error name
Error
Operation status at error occurrence
910
Setting range outside OPR
method
The setting value of " OPR. 1 OPR method" is outside
the setting range.
911
Setting range outside OPR
direction
The setting value of " OPR. 2 OPR direction" is
outside the setting range.
913
Setting range outside OPR
speed
•
The setting value of " OPR. 4 OPR speed" is outside
the setting range.
•
The setting value of " OPR. 4 OPR speed" is lower
than " Pr. 6 Bias speed at start".
•
The setting value of " OPR. 4 OPR speed" is higher
than " Pr. 5 Speed limit value".
914
Setting range outside creep
speed
•
The setting value of " OPR. 5 Creep speed" is
outside the setting range.
•
The setting value of " OPR. 5 Creep speed" is higher
than " OPR. 4 OPR speed".
•
The setting value of " OPR. 5 Creep speed" is lower
than " Pr. 6 Bias speed at start".
915
Setting range outside
ACC/DEC time at OPR
The setting value of " OPR. 6 ACC/DEC time at OPR"
is outside the setting range.
916
Setting range outside
DEC/STOP time at OPR
The setting value of " OPR. 7 DEC/STOP time at
OPR" is outside the setting range.
917
Setting range outside
setting for the movement
amount after near-point dog
ON
The setting value of " OPR. 8 Setting for the
movement amount after near-point dog ON" is outside
the setting range.
918
Setting range outside stop
mode during path control
The setting value of " Pr. 10 Stop mode during path
control" is outside the setting range.
The module READY signal (X0) does not turn
ON.
Summary of Contents for GX Configurator-PT
Page 13: ...MEMO SECTION 1...
Page 127: ...7 20 7 20 MELSEC Q 7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL MEMO...
Page 129: ...MEMO SECTION 2...
Page 221: ...Index 5 Index 5 MEMO...
