Mitsubishi GX Configurator-PT, User Manual

Page: 188 / 224

13 - 4 13 - 4
MELSEC-Q
13 TROUBLESHOOTING
Related buffer memory address
Axis 1 Axis 2 Axis 3 Axis 4 Axis 5 Axis 6 Axis 7 Axis 8
Setting range Remedy
— — — — — — — — — —
— — — — — — — — —
•
Check that there is no influence from
noise.
•
Check hardware for possibility of fault.
— — — — — — — — —
After switching power from OFF to
ON/resetting the PLC CPU, turn ON the
PLC READY signal (Y0) again, make
sure that the module READY signal (X0)
is ON, and then make a start. (The
module is faulty if the module READY
signal (X0) does not turn ON.)
— — — — — — — — —
Check whether the axis stop signal (Y10
to Y17) is ON or OFF and turn OFF the
axis stop signal that is ON.
Pr. 1 Software stroke limit upper limit value
0
1 100
101 200
201 300
301 400
401 500
501 600
601 700
701
Pr. 2 Software stroke limit lower limit value
2
3 102
103 202
203 302
303 402
403 502
503 602
603 702
703
Da. 6 Positioning address/movement amount
(Refer to Section 4.5)
-2147483648 to 2147483647 (pulse)
At start: Perform JOG operation (Refer to
Chapter 10) to change "Md. 1
Current feed value" to within the
software stroke limit range.
Current value changing:
Change the new current value to
within the software stroke limit
range (Refer to Section 9.2.4).
During operation:
Correct " Da. 6 Positioning
address/movement amount"
(Refer to Section 4.5).
— — — — — — — — —
— — — — — — — — —
Review the sequence program that turns
ON/OFF the PLC READY signal (Y0).
— — — — — — — — —
Perform JOG operation (Refer to
Chapter 10) to move the axis to the
position where the near-point dog turns
OFF, and then start machine OPR
control (Refer to Section 8.2.3, Section
8.2.7 and Section 8.2.8).
— — — — — — — — —
After turning OFF the zero signal, start
machine OPR control (Refer to Section
8.2.5 and Section 8.2.6).
5 152 252 352 452 552 652 752
Cd. 3 Start method
0 : Positioning control
9000 : Machine OPR control
9001 : Fast OPR control
Before starting fast OPR control, perform
machine OPR control (Refer to Section
8.2).