7 - 8 7 - 8
MELSEC-Q
7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
7.4 Positioning control program examples
An example of the "Axis 1" positioning control program is given in this section.
[No.1] to [No.3] parameter and data setting program
When setting the parameters or data with the sequence program, set them in the QD70 using the
TO command from the PLC CPU. (Carry out the settings while the PLC READY signal [Y0] is OFF.)
When setting the parameters or data with the GX Configurator-PT, the [No.1] to [No.3]
program is not necessary.
No.1 Parameter setting program
No.2 OPR data setting program
Summary of Contents for GX Configurator-PT
Page 13: ...MEMO SECTION 1...
Page 127: ...7 20 7 20 MELSEC Q 7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL MEMO...
Page 129: ...MEMO SECTION 2...
Page 221: ...Index 5 Index 5 MEMO...
