Mitsubishi FX2N-10GM, Hardware / Programming Manual

Page: 188 / 274

FX Series Positioning Controllers Communication with Programmable Controller 7
7-2
7.2 Buffer Memories
7.2.1 Configuration of the buffer memories
The buffer memories correspond to the device memories such as parameters, various special
Ms and various special Ds as shown in the configuration diagram on the previous page. (For
details, refer to Section 6.)
• The buffer memory No. is indicated as "#". One point consists of 16-bit data.
• Bit devices such as auxiliary relays, I/O relays, etc.in the positioning unit and word devices
such as data registers, parameters, etc. are assigned to 16-bit data in the buffer memories.
• Each bit of the buffer memories to which bit devices are assigned operates differently.
Example: BFM#20
The figure above shows the buffer memory #20. The special auxiliary relays M9000 to
M9015 are assigned to #20. For example, M9001 (X axis start command) is assigned to Bit
1 of #20. When a sequence program is created so that this bit is turned ON by the TO
instruction (writing to the buffer memories), the start command is given.
• The buffer memory to which a word device is assigned expresses a single value in 16 bits or
32 bits.
Example: BFM#9000
D9000 is assigned to the buffer memory #9000.
By wiring data to #9000 using the TO instruction, you can specify the program No.
As to word devices, the buffer memory No. is equivalent to the special data register No.
M9015
Continuous
path mode
M9014
16-bit
command
b15 b14
M9002
Stop
command
M9001
Start
command
b2 b1
M9000
Single-step
command
b0
Intermediate bits are omitted in description.
#20
Not defined in the FX
2N
-10GM.
D9000: Program No. specification.
16-bit data (binary)
#9000