Mitsubishi FX2N-10GM, Hardware / Programming Manual

Page: 17 / 274

FX Series Positioning Controllers Introduction 1
1-5
1.4.2 Installation method
The positioning unit can be directly attached to a DIN rail DIN46277 (width: 35 mm).
When removing the positioning unit, slightly pull out the DIN rail hook.
When the DIN rail hook is pulled out by one more step, it can be locked in the open status.
When using an extension block for the
FX
2NC
Series together with the FX
2N
-20GM,
push out the mounting hook in the arrow
direction shown in the figure on the right,
when attaching it to the DIN rail.
(An extension block cannot be connected to
the FX
2N
-10GM.)
1.4.3 MANU/AUTO selector switch
Set this switch to "MANU" for manual operation, or to "AUTO" for automatic operation.
Select the MANU mode when writing programs or setting parameters.
In the MANU mode, positioning programs and subtask programs stop.
When this switch is changed over from "AUTO" to "MANU" during automatic operation, the
positioning unit performs the current positioning operation, then waits for the END instruction.
Removal
Locked hook
When attached
to DIN rail
When directly attached
(at shipment)
Extension
block
READY-y
ERROR-x
READY-x
BATT
CPU-E
ERROR-y
POWER
MANU
AUTO
MANU/AUTO
selector switch