10
10-214
Ver.0.10
MULTIJUNCTION TIMERS
10.9 TOM (Output-related 16-bit Timer)
10.9.9 TOM Count Enable Registers
■
TOM0 Count Enable Register (TOM0CEN)
<Address: H'0080 0CDF>
D8
9
10
11
12
13
14
D15
TOM00CEN TOM01CEN TOM02CEN TOM03CEN TOM04CEN TOM05CEN TOM06CEN TOM07CEN
<When reset:H'00>
D
Bit Name
Function
R
W
8
TOM00CEN
0: Stops count
(TOM0_0 count enable)
1: Enables count
9
TOM01CEN
(TOM0_1 count enable)
10
TOM02CEN
(TOM0_2 count enable)
11
TOM03CEN
(TOM0_3 count enable)
12
TOM04CEN
(TOM0_4 count enable)
13
TOM05CEN
(TOM0_5 count enable)
14
TOM06CEN
(TOM0_6 count enable)
15
TOM07CEN
(TOM0_7 count enable)
The TOM0 Count Enable Register controls operation of TOM0 counters. To enable the counter in
software, enable the relevant TOM0 Enable Protect Register for write and set the count enable bit
by writing a 1. To stop the counter, enable the TOM0 Enable Protect Register for write and reset the
count enable bit by writing a 0.
In single-shot output and single-shot PWM output modes, when the counter stops due to an
occurrence of underflow, the count enable bit is automatically reset to 0. Therefore, what you get by
reading the TOM0 Count Enable Register is the status that indicates the counter's operating status
(active or idle).
Summary of Contents for M32170F3VFP
