Mitsubishi Electric FR-E800, Instruction Manual

Page: 328 / 484

11
12
13
14
15
16
17
18
19
20
327
13. (T) Multi-Function Input Terminal Parameters
13.5 Torque (magnetic flux) setting current (voltage) bias and gain
 Adjustment by changing the torque without adjusting the current (voltage) (Example of
changing the gain torque from 150% to 130%)
Operating procedure
1.
Selecting the parameter
Turn the setting dial or press the UP/DOWN key until "C40" (
Pr.933 ) appears.
Press the SET key to show the present set value. (150.0%)
2.
Torque setting change
Turn the setting dial or press the UP/DOWN key to change the value to "130.0". (130.0%)
Press the SET key to confirm the setting. "130.0" blinks.
3.
Selecting the mode and the monitor item
Press the MODE key three times to select the monitor mode and to monitor a frequency.
4.
Start
Turn ON the start switch (STF or STR) to apply a voltage across terminals 4 and 5.
Operation is performed with 130% torque.
NOTE
• If the current (voltage) values at the gain and bias torques are too close to each other, an error ("Er3") may be indicated.
• Use the calibration parameter
C38 (Pr.932) to set the bias torque. (Refer to page 323 .)
Parameters referred to
Pr.20 Acceleration/deceleration reference frequency  page 196
Pr.267 Terminal 4 input selection  page 310
Pr.79 Operation mode selection  page 212
Pr.858 Terminal 4 function assignment  page 315
CAUTION
• When setting a value other than "0" as the bias torque, note that simply turning ON the start signal will supply torque to
the motor even if a torque command is not given.