Mitsubishi Electric apricot VS660, System Product Manual

Page: 66 / 154

System Product Guide
4-15
OM04081
C
B
A
Figure 4-8. Removing the Floppy Disk Drive
Installing a Floppy Disk Drive
1. Observe the precautions in “Before You Begin.”
2. Remove the 3.5-inch drive carrier from the system.
3. Remove the floppy disk drive from its protective wrapper and place it
on an antistatic surface.
4. Set any drive jumpers or switches according to the manufacturer’s
instructions.
5. Slide the floppy drive into the 3.5-inch drive carrier. Line the holes on
the carrier up with the screw holes on the drive.
6. Insert and tighten four screws of the appropriate size and length (not
supplied).
7. Install the 3.5-inch drive carrier.
8. Attach the power cable and the data cable to the drive.