Mitsubishi Electric apricot VS660, System Product Manual

Page: 103 / 154

6-8
Solving Problems
Problems and Suggestions
Contact your service representative if the suggested actions don't solve the
problem.
What happens What to do
Application software
problems Make sure all cables are installed correctly.
Verify that the system board jumpers are set properly.
Verify that your system hardware configuration is set correctly. In
Setup, check the values against the system settings you recorded
previously. If an error is evident (wrong type of drive specified, for
example), make the change in Setup and reboot the system.
Record your change.
Make sure the software is properly configured for the system.
Refer to the software documentation for information.
Try a different copy of the software to see if the problem is with the
copy you are using.
Try running the software in a different speed mode. See "Using
Keyboard Shortcuts" in Chapter 2.
If other software runs correctly on the system, contact the vendor
of the software that fails.
If you check all of the above with no success, try clearing CMOS
RAM (Chapter 5) and reconfiguring the system. Make sure you
have your list of system settings available to re-enter, because
clearing CMOS RAM sets the options to their default values.
Characters on-screen are
distorted or incorrect Make sure the brightness and contrast controls are properly
adjusted.
Make sure the video signal cable and power cables are properly
installed.
Make sure your monitor is compatible with the video mode you
have selected.