Matrix ETERNITY NE, System Manual

Page: 487 / 996

Matrix ETERNITY NE System Manual 477
• At Location A , you need to configure the Closed User Group Table in ETERNITY NE:
The CUG Table stores up to 8 entries. You must configure the following parameters in the table:
• Route Code: The Route Code is the truncated number string for the extension numbers of the other
PBX. The truncated number string must start with the starting digit of the extension numbers. In this
case, all extension numbers of PBX A start with ‘3’, so you can configure the Route Code as a single
digit, ‘3’.
• Strip Digit Count: This parameter is not relevant for this application. Keep the Strip Digit Count as ‘0’.
• Self Route: This flag is not relevant for this application; keep it disabled.
• Dialed Digit Count : This is the digit length of the extension numbers of PBX A
29
. Here all extension
numbers of PBX A have three digits, the Dialed Digit Count should be configured as ‘3’.
• Route using Trunks : This is the number of the Tie Trunk that the system should use for routing the
dialed number string that matches with the Route Code and Dialed Digit Count.
It the CUG is connected over Analog Trunks , you must select the CO Trunk you have connected to
the SLT (FXS) port of PBX A.
If the CUG is connected over IP network , you must select the SIP Trunk which you have used for this
application.
The CUG Table you configure on ETERNITY NE would look like this:
• At Location B, you may do a suitable configuration of the PBX. If the PBX at Location B were ETERNITY,
the CUG Table you configure would look like this:
29. When digits are dialed on a trunk, the system waits for the Inter Digit Wait Timer after the last digit is dialed. The Dialed Digit Count
helps avoid the delay caused by the Inter Digit Wait Timer. When you configure the digit length, the system will match the dialed
number string with the digit length you have configured and will route the number without waiting for the Inter Digit Wait Timer, if a
match is found.
Route Index Route Code
Strip
Digit
Count
Self Route
Dialed
Digit
Count
LCR Route using Trunks
1 3 0 Disabled 3 Off CO2
2
:
8
Route Index Route Code
Strip
Digit
Count
Self Route
Dialed
Digit
Count
LCR Route using Trunks
1 2 0 Disabled 3 Off CO2
2
:
8