215676
72
Revision A
•
RETURN-TO-CUT HEIGHT SWITCH (G): this switch allows the Operator to make use of the cutting height preset. Push
the switch to enable this feature; push it again to disable it.
NOTE:
Return-to-cut height switch (G) will light up when this feature is enabled.
3.19.3
Operating Screens
The display screen on the cab display module (CDM) reports performance information about the windrower and its
attached header. Refer to this section to learn the precise meaning of the messages seen on the upper and lower lines of
the display. The message categories in this section are organized according to the state of the windrower (for example,
whether or not the engine is running) and the state of the header (for example, whether or not the header is engaged).
1000647
A
B
C
D
E
Figure 3.59: CDM Operating Screen
A - Display Selector for Upper Line
B - Display
C - CDM Upper Line
D - CDM Lower Line
E - Display Selector for Lower Line
Ignition ON, Engine Not Running
These are the messages which can appear in the cab display module (CDM) when the ignition key is in the RUN position,
but the engine has not been started.
Display (Upper Line) (2
–
3 Seconds)
Description
HEADER DISENGAGED
Indicates that the HEADER DRIVE switch is OFF
IN PARK
Indicates that the ground speed lever (GSL) is in the N-DETENT position
